Cleaning, Sanitizing and Protecting Protocol
- Clean and Sanitize frequently touched surfaces daily. This includes tables, doorknobs, light switches, countertops, handles, desks, phones, keyboards, toilets, faucets, sinks, etc.
- If surfaces are dirty, clean them: Use detergent or soap and water prior to sanitizing.
- PROTECT surfaces to inhibit the growth of odor causing bacteria.
INSTRUCTIONS
1. REMOVE any loose debris and where applicable, wipe surface with damp rag.
2. CLEAN: Using EnviroSystems Green Kleen 420-4 (ready to use):
- Hold sprayer about eight inches from surface to be cleaned.
- Spray on and wipe it off! On extremely dirty surfaces, allow to penetrate and leave on surface for 2-3 minutes. Apply second spray if needed, and wipe.
- Wipe surface with clean, damp sponge or cloth.
- For removal of built-up, caked on grime, or for best results when cleaning rough irregular surfaces, spray on, agitate with brush, rinse and wipe.
3. DISINFECT: using an EPA-registered List N disinfectant such as Novalent Sanitizer + Disinfectant –EPA REG. NO. 6836-348-53053
- Apply solution with a cloth, sponge, or hand pump trigger sprayer to wet all surfaces thoroughly. Allow the surface to remain wet for 10 minutes.
- Let dry
4. PROTECT: Using EnviroSystems BioShield 75:
- Using a trigger sprayer, spray the entire surface area 4”-6” from the surface making sure the surface is completely covered.
- Let stand until dry (5-10 minutes)
*Using the protocol as directed will be effective in killing and protecting against viruses.